Raison Automation

MAKE: ELECTRONET
MODEL: ELMAG 600 
TRANSMITTER: FIELD MOUNT WEATHER PROOF IP67
POWER SUPPLY: Battery Operated
MOC OF TRANSMITTER: ALUMINIUM DIE CAST
ELECTRICAL CONNECTION : M20*1.5F
OUTPUT 1:  HART
COMMUNICATION : RS 485 MODBUS/GSM
PROCESS PRESSURE: 10 KG
FLOW TUBE : DN 25 - DN 2000
ELECTRONICS LOCATION:REMOTE
REMOTE CABE LENGTH :5 METER
FLOW TUBE PROTECTION CLASS : IP 68

Product Description

Electronet Series AFM TX-22 is a DP Flow Meter suitable for flow measurement of compressed air. It is integrally mounted with the inbuilt flow transmitter. It is compact and complete flow meter to measure the flow rate of compressed air. The flow meter works on differential pressure flow measurement principle. It includes LCD display for Pressure, Flow Rate and Totalized value with engineering units. Flow meter is available with Socket Weld, Threaded and Flanged end connections.

ULTRASONIC LEVEL TRANSMITTER
Non-contact maintenance free measurementsHigh Contamination ToleranceEasy to InstallMeasuring Range : 6mtr / 8mtr / 10mtr / 15mtrLCD Display4 to 20mA with HART communicationNarrow Beam TechnologyIP 67 / IP 68

Working Principle

The Turbine Flow meter is used for the measurement of liquid flow rate. It works on the principle of Turbine. A turbine flow meter is constructed with rotor and blades that use the mechanical energy of the fluid to rotate the rotor in the flow stream. Blades on the rotor are angled to transform energy from the flow stream into rotational energy. The rotor shaft spins on bearings - When the fluid moves faster, the rotor spins proportionally faster.

 

The diameter of the rotar is slightly less than the inside diameter of the pipe, and its speed of rotation is proportional to the volumetric flow rate. The magnetic pick-up coil consists of a permanent magnet with coil windings which is mounted in close proximity to the rotor. As each rotor blade passes the magnetic pick-up coil, it generates a voltage pulse which is a measure of the flow rate. The total number of pulses gives a measure of the total flow.

Product Description

Electronet series FL-100 are Two Wire Turbine Flow Transmitters specially used for various industrial applications. The flowing media engages a vaned rotor causing it to rotate at an angular velocity proportional to flow rate. The pick-up coil senses the spinning motion of the rotor inside the pipe & converts it into a pulsating electrical signal. Summation of the pulsating electrical signal is directly related to the total flow.

The frequency is linearly proportional to flow rate which is converted to electrical signal 4 - 20 mA. Turbine flow meters are preferred for clean, filtered, low viscosity fluids. The typical accuracy and repeatability of turbine flow meters are Plus/Minus 0.5% and Plus/Minus 0.1%, respectively. However, it is possible to achieve accuracy of Plus/Minus 0.25% and repeatability of Plus/Minus 0.05%.

Turbine flow meters are inherently sensitive to Reynolds number. They will not be linear at Reynolds numbers nearing or in the laminar region. Therefore, they should be carefully used in the case of fluids with a broad temperature and viscosity range such as some oils. It is not a problem at constant conditions, but is often hard to achieve practically.

FeaturesOn-Line PH / ORPMeasurement2 Wire System4-20 mA DC Output / 4-20 mA with HART (Generic)Simple operating interface with basic PictographsOn-Line Indication through LCD DisplayEasy InstallationAuto / Manual Temperature Compensation